Axiom GPS Module
We no longer carry this item in our store
Description
The module is already RS-232 ready, no need for a level converter chip (MAX-232). For a serial connection to your PC all you need to do is apply power(+5vdc) and wire TX,RX, and ground to you PC. Once powered up the receiver will output NMEA at 4800,8,n,1. You can add a battery backup (3.6vdc) connected to pin 3. This will allow the receiver to lock onto a signal within 10 seconds. On first power up don't expect a lock for about 90 to 120 seconds.
The module has two rows of pins, the pin with the square pad is pin 1.
Thanks to Alan N5NA for the following diagram.
Parts for the J1 connector are available from:
http://www.mouser.com
Housing P/N 538-511102050
Socket P/N 538-50394-8100
Documents
Conductor User Guide
Evaluation User Guide
GPS Message Specification
Software
Specifications
General:
- Standard Log Capacity 5000 position and event records in non-volatile memory
- Optional Log Capacity 25000 position and event records in non-volatile memory
- Discretes 4 Programmable as Input or Output
Architecture:
- Channels 12 simultaneous, all-in-view<li> <li>Frequency L1 1575.42 MHz
- Tracking C/A code & carrier
- Flash ROM 256 k x 16
- Static RAM 64 k x 16
- Processor Speed Hitachi SH-1 at 12.288 MHz
Dynamics:
- Altitude -1000 m to 18,000 m
- Velocity 500 meters per second
- Acceleration 4 g
- Jerk 5 meters/second3
Acquisition:
- Cold Start < 50 seconds (average)
- Warm Start < 40 seconds (current position, time, and almanac)
- Hot Start < 8 seconds (current position, time, almanac, and ephemeris)
- Snap Start 3.5 seconds (average)
- Reacquisition 100 milliseconds
Accuracy:
- Position (SA on) 100 meters 2d RMS
- Position (SA off) < 25 meter SEP
- DGPS 1 to 5 meters
- Timing, 1PPS (SA on) < 300 ns, dynamic
- Timing, 1PPS (SA off) < 75 ns, dynamic
- Receiver Sensitivity -143.5 dB-Hz
Physical:
- Dimensions 41.91 x 71.88 x 8.76 mm (1.65 x 2.83 x 0.35 in)
- Weight 19.84 g (0.7 oz)
Electrical:
- Operating Voltage 5 ± 0.25 Vdc, 50 mVp-p (max)
- Power Consumption: 180 mA (continuous on)
Environmental:
- Operating Temperatures -40° to + 85° C
- Storage Temperatures -55° to + 125° C
- Operating Humidity 5% to 95% R.H., Non-condensing, @ + 60° C
- Shock 20 g (11 ms saw tooth)
- Vibration 4 g
20 pin Connector (J1) Pin out
| PIN # | I/O1 | Signal Name | Description |
|---|---|---|---|
| 1 | I | ANT_PWR | DC power to active antenna. Connect 5 or 3 volts, depending on the active antenna being used. Typically 20 to 30ma. |
| 2 | I | VCC_5V | Regulated 5.0VDC +/- 5% input power. 180mA typical. |
| 3 | I | VBAT | Battery backup input. 2V to VCC + 0.5 V. 10uA typical. |
| 4 | I | N/C | |
| 5 | I | PBRESN | Manual reset input (ground to reset receiver). Leave floating for normal operation. The minimum pulse width is 10 us resulting in a 140 ms reset signal. |
| 6 | I/O | GPIO1 | General purpose I/O 1 |
| 7 | I/O | GPIO2 | General purpose I/O 2 |
| 8 | I/O | GPIO3 | General purpose I/O 3 |
| 9 | I/O | GPIO4 | General purpose I/O 4 |
| 10 | I | GND | Ground |
| 11 | O | TXA | Port A Serial Transmit Data. VCC CMOS levels. GPS messages. |
| 12 | I | RXA | Port A Serial Receive Data. VCC CMOS levels. GPS commands. |
| 13 | I | GND | Ground |
| 14 | O | TXB | Port B Serial Transmit Data. VCC CMOS levels. |
| 15 | I | RXB | Port B Serial Receive Data. VCC CMOS levels. Differential GPS messages. |
| 16 | I | GND | Ground |
| 17 | I | BOOT | Reserved for re-programming flash |
| 18 | I | GND | Ground |
| 19 | O | TIMEMARK | 1PPS (one pulse per second) output. Normally low with 100ms high pulse once every second |
| 20 | I | PWRONOFF | Reserved for future implementation of Push-to-Fix |
Minimum connections to make receiver work:
| 1 | I | ANT_PWR | DC power to active antenna. Connect 5 or 3 volts, depending on the active antenna being used. Typically 20 to 30ma. |
| 2 | I | VCC_5V | Regulated 5.0VDC +/- 5% input power. 180mA typical. |
| 3 | I | VBAT | Battery backup input. 2V to VCC + 0.5 V. 10uA typical. |
| 11 | O | TXA | Port A Serial Transmit Data. GPS messages. |
| 12 | I | RXA | Port A Serial Receive Data. GPS commands. |
| 13 | I | GND | Ground |
Summary of Features Installed:
- Power = +5vdc
- Data Connector = Bottom Feed
- RF Connector = Right angle SMA
- ROM & RAM Sizes = 4 Megabits Flash ROM; 1 Megabits RAM
- Super Cap = NOT INSTALLED
- Data = RS-232 Interface
- Software = NMEA @ 4800 baud, 8 N, 1